This article will show you guide on how to configure wireless DLA+2.0 for JPRO.
Preparation:
JPRO 2019 Commercial Vehicle Diagnostics Software Download & Installation Service
JPRO Professional Heavy Duty Diagnostic Software Download
Before beginning Wireless configuration,You must first install the necessary drivers before configuring the DLA+2.0 Wireless Adapter to work with your PC for diagnostic applications. Please be sure to follow the instructions in the Installation section beginning on page14. The DLA+2.0 Wireless Minder After drivers are installed, your System Task Bar displays the DLA+2.0 Wireless Minder icon (if your system is set to display Task Bar icons)
If you scroll your cursor over the icon, the message,“DLA+2.0 Wireless Minder: No Adapter IP Found” will appear.
If you right click on the icon and select “Show Details”,a box will display that your DLA+2.0 Wireless Adapter is not yet configured and therefore not getting a signal as indicated by the red “Round Trip Time(ms)”status bar.
Once you have configured and assigned an IP address to the DLA+2.0Wireless Adapter, connected to a wireless network, and there reception is strong, the status bar will become green.As just noted,even after you have configured your DLA+2.0 Wireless Adapter toa wireless network,you may get apoor transmission signal.To ensure a stronger signal,you may need to move your PC and DLA+2.0 Wireless Adapter closer to each other.
NOTE: Before setting up a connection between your PC and the DLA+2.0Wireless Adapter,you must know if you will use a local/corporate network or peer‐to‐peer connection. It is recommended you contact your network administrator forlocal /corporate network configuration.
没有评论:
发表评论